[Fusionforge-general] required PHP version
AlJeux
aljeux at free.fr
Mon Nov 23 21:58:07 CET 2009
Keith.DeSolla at Zarlink.Com a écrit :
>
> Can anyone tell me if fusionforge works fine with php-5.1.6? That is
> the version that comes with RHEL5 and I would like to know if I can live
> with that, or if I need to go through the work of upgrading since a
> RHEL5 RPM for php-5.2x isn't available.
Yes.
The automated test suite and the demo site is based on RHEL5 and using
php5.1.6.
Alain.
> The install guide says the following under "Software Requirements":
>
> PHP 5.2 or later (php4 with the command line interface support and
> php5.1 should work)
>
> thanks
> -keith
>
>
> --
> ZARLINK Semiconductor
> Keith de Solla
> MTS CAD Engineer
> Communications Products group
> Office: 512-228-5467 | Fax: 512-228-5510
> keith.desolla at zarlink.com | www.zarlink.com
>
> ----------
> This email is confidential and may contain information that is privileged and
> exempt from disclosure by law. If you have received it in error, please contact
> the sender immediately by return email and then delete it from your system; you
> should not copy it or disclose its contents to anyone. Emails are not secure
> and cannot be guaranteed to be error free as they can be intercepted, amended,
> lost or destroyed, or contain viruses. Anyone who communicates with us by email
> is taken to accept these risks.
>
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Fusionforge-general mailing list
> Fusionforge-general at lists.fusionforge.org
> http://lists.fusionforge.org/cgi-bin/mailman/listinfo/fusionforge-general
More information about the Fusionforge-general
mailing list